Performance indicators and parameters of CoolingSystem APC ACRC monitored by Moein are:

Device General Info:

1. Name
2. Address
3. Port Number
4. Hostname
5. Model
6. Vendor
7. Location
8. Serial Number
9. Firmware Version
10. Hardware Revision
11. Manufacturer Date
12. Availability

Group Status:

1. Group Coolant Output
2. Group Coolant Demand
3. Group Air Flow
4. Group Maximum Rack Inlet Temperature
5. Group Minimum Rack Inlet Temperature
6. Active Flow Control System Status
7. Group Cooling Set Point
8. Supply Air Set Point
9. Preferred Fan Speed Setting
10. Fan Speed Control Setting
11. Active Flow Control Bias Setting
12. Group Number Of Cooling Units
13. Group Configuration Type
14. Percentage Of Glycol Mixture
15. Gain Component Of The PID
16. Integral Component Of The PID
17. Derivative Component Of The PID
18. Maximum Desired Fan Speed
19. Number Of Active Flow Controllers
20. Controller Lamp Test Status
21. Altitude Of The Units Above Sea Level

Unit Status:

1. Cooling Unit Operating Mode
2. Unit Cooling Output
3. Unit Cooling Demand
4. Unit Air Flow
5. Unit Rack Inlet Temperature
6. Unit Supply Air Temperature
7. Unit Return Air Temperature
8. Unit Containment Differential Pressure
9. Unit Air Filter Differential Pressure
10. Unit Average Fan Speed
11. Input Contact State
12. Output Relay State
13. Unit Power Source
14. Fluid Valve Position
15. Fluid Flow
16. Entering Fluid Temperature
17. Leaving Fluid Temperature
18. Leak Sensor State
19. Unit Air Filter Running Duration
20. Unit Fan 1 Running Duration
21. Unit Fan 2 Running Duration
22. Unit Fan 3 Running Duration
23. Unit Fan 4 Running Duration
24. Unit Fan 5 Running Duration
25. Unit Fan 6 Running Duration
26. Unit Fan 7 Running Duration
27. Unit Fan 8 Running Duration
28. Unit Fan Left Power Supply Running Duration
29. Unit Fan Right Power Supply Running Duration
30. Unit Condensate Pump Running Duration
31. DC Power Feed A Left Power Supply Running Duration
32. DC Power Feed A Right Power Supply Running Duration
33. DC Power Feed B Left Power Supply Running Duration
34. DC Power Feed B Right Power Supply Running Duration

Unit Configuration Threshold and configs:

1. Air Filter Service Interval
2. Air Filter Service Interval Alarm
3. Unit Rack Inlet Air High Temperature Threshold
4. Unit Supply Air High Temperature Threshold
5. Unit Return Air High Temperature Threshold
6. Unit Incoming Fluid High Temperature Threshold
7. Cooling Capacity Options Setting
8. Startup Delay
9. Idle On Leak Detection
10. Configured Power Source Of The Unit
11. Normal State Of The Input Contact
12. Normal State Of The Output Relay
13. Source Of Output Relay Change
14. Idle On Cool Failure